X
Comments to #2
All comments (5)
4
1.
Hallie 3 year s ago
#6 brilliant
-2
2.
Midge 3 year s ago
most of these could be purchased and assembled cheaper than a 3d printer.
-2
3.
Peregrine 3 year s ago
#27 i want a dash size of this one ... in a statue i mean .... that could be decoupaged from a picture 
2
4.
Rhynie 3 year s ago
Quite a bit of junk and doodads. Hardly worth it.
0
5.
Mat 3 year s ago
#24 Couldn't have wait for the last percent to post on the internet.
"After Modding My Ender3 V2 To Do 400mm High Prints I Revisited My Prosthetic Cover Design, Printed Full Height, No Cut Or Seam At The Bottom, Raindrop Rear Case, Tpu Gaskets To Damp Sound...best Of All, 40% Lighter. Well Pleased."
4
1.
Hallie 3 year s ago
#6 brilliant
-2
2.
Midge 3 year s ago
most of these could be purchased and assembled cheaper than a 3d printer.
-2
3.
Peregrine 3 year s ago
#27 i want a dash size of this one ... in a statue i mean .... that could be decoupaged from a picture
2
4.
Rhynie 3 year s ago
Quite a bit of junk and doodads. Hardly worth it.
0
5.
Mat 3 year s ago
#24 Couldn't have wait for the last percent to post on the internet.